Instrument-Shutdown and Startup

Access the resources below to ensure proper shutdown and start-up of your analytical instruments. For additional information or help, please contact your local Shimadzu representative.

Elemental Analysis

Learn more about Elemental Analysis Products

AA - Preparing your instrument for shutdown

AA Shutdown Procedure 

ICP - Preparing your instrument for shutdown

ICP Shutdown Procedure 

ICPMS - Preparing your instrument for shutdown and startup

ICPMS Shutdown and Startup Procedures 

Gas Chromatography

Learn more about Gas Chromatography Products

Preparing your Shimadzu Gas Chromatograph for Shutdown

Gas Chromatography Shutdown Procedure 

Preparing your Shimadzu Gas Chromatograph for Startup

Gas Chromatography Startup Procedure 

Gas Chromatography/Mass Spectrometry (GC-MS)

Learn more about Gas Chromatography Mass Spectrometry Products

Preparing your Shimadzu GC-MS or GC-MSMS for Shutdown

Gas Chromatography Mass Spectrometry Shutdown Procedure 

Preparing your Shimadzu GC-MS or GC-MSMS for Startup

Gas Chromatography Mass Spectrometry Startup Procedure 

 

Liquid Chromatography

Learn more about Liquid Chromatography Products

Good practices recommended for shutting down HPLC systems

HPLC Shutdown Procedure 

Liquid Chromatography / Mass Spectrometry (LC-MS)

Learn more about Liquid Chromatography Mass Spectrometry Products

Extended storage of LC/MS and LC/MS/MS under vacuum.

Extended Storage Procedure 

Manual vacuum start-up and shutdown procedures for Triple Quads.

Manual Vacuum Shutdown Procedure 

Manual vacuum procedure for QTOF

Manual Vacuum Pump Procedure 

Molecular Spectroscopy

Learn more about Molecular Spectroscopy Products

Shut down: If the instrument (UV-Vis, FTIR and Fluorescence) is not going to be used for an extended period, please, close the software and turn off the power switch. This will help in preserving the life of their lamps.

Start up: To start up your instrument, power it on using the power switch/button on the instrument, and then open the operating software. Once connected to the software, the instrument will begin the initialization procedure (less than one minute to a few minutes depending on the instrument). Once completed, it will be ready to operate.

Software and Informatics

Learn more about Software and Informatics Products

Shutting down LabSolutions Client/Server

LabSolutions Shutdown Procedure 

Total Organic Carbon (TOC) Analyzer

Learn more about Total Organic Carbon (TOC) Analyzer Products

TOC - Preparing your instrument for shutdown

TOC Shutdown Procedure 

Kategorie-Name: 
Support

For Research Use Only. Not for use in diagnostic procedures.

This page may contain references to products that are not available in your country. Please contact us to check the availability of these products in your country.